Onboard Audio Function - Gigabyte GA-MA790X-DS4 User Manual

Legacy IDE
SATA ->AHCI Configures the SATA controller to AHCI mode. Advanced Host Controller

Onboard Audio Function

Enables or disables the onboard audio function. (Default: Auto)
If you wish to install a 3rd party add-in audio card instead of using the onboard audio, set this item
to Disabled.
Onboard 1394 Function
Enables or disables the onboard IEEE 1394 function. (Default: Enabled)
Onboard LAN Function
Enables or disables the onboard LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item
to Disabled.
Onboard LAN Boot ROM
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip.
(Default: Disabled)
SMART LAN (LAN Cable Diagnostic Function)
Start detecting at Port.....
Pair1-2 Status =
Pair3-6 Status =
Pair4-5 Status =
Pair7-8 Status =
: Move Enter: Select
F5: Previous Values
This motherboard incorporates cable diagnostic feature designed to detect the status of the attached LAN
cable. This feature will detect cabling issue and report the approximate distance to the fault or short.
Refer to the following information for diagnosing your LAN cable:
When No LAN Cable Is Attached...
If no LAN cable is attached to the motherboard, the Status fields of all four pairs of wires will show
Open and the Length fields show 0.0m, as shown in the figure above.
GA-MA790X-DS4 Motherboard
Allows the SATA controller to operate in Legacy IDE mode. In Legacy mode the
SATA controller uses dedicated IRQs that cannot be shared with other device.
Set this option to Legacy IDE if you wish to install operating systems that do not
support Native mode, e.g. Windows 9X/ME
Interface (AHCI) is an interface specification that allows the storage driver to
enable advanced Serial ATA features such as Native Command Queuing and
hot plug. For more information about AHCI, please visit Intel's website.
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
Open / Length
Open / Length
Open / Length
Open / Length
+/-/PU/PD: Value
F6: Fail-Safe Defaults
SMART LAN
= 0.0m
= 0.0m
= 0.0m
= 0.0m
F10: Save
- 44 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults