Gigabyte GA-MA69G-S3H User Manual page 72

B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup .
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test).
Under Integrated Peripherals, ensure OnChip SATA Controller is enabled. To create RAID, set
OnChip SATA Type under the Integrated Peripherals menu to RAID (Figure 1).
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
IDE Configuration
OnChip SATA Controller
OnChip SATA Type
Onboard Audio Function
Onboard 1394 Function
Onboard LAN Function
Onboard LAN Boot ROM
OnChip USB Controller
USB EHCI Controller
USB Keyboard Support
USB Mouse Support
Legacy USB storage detect
Onboard Serial Port
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
: Move Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your
motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard
you have and the BIOS version.
GA-MA69G-S3H Motherboard
Integrated Peripherals
[Press Enter]
[Enabled]
[RAID]
[Auto]
[Enabled]
[Enabled]
[Disabled]
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Enabled]
[2F8/IRQ3]
[378/IRQ7]
[SPP]
3
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
Figure 1
- 72 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults