Gigabyte GA-M52S-S3P User Manual page 76

Step 3:
When installing the RAID driver, for example, if Setup correctly recognizes the driver in the floppy disk,
a controller menu similar to that in Figure 3 below will appear. Use the arrow keys to select NVIDIA
(Note)
RAID Driver and press <Enter>. Later, when a screen similar to that in Figure 4 appears, you must
press <S> to select an additional driver. The screen will return to previous screen as shown in Figure
3. Select NVIDIA nForce Storage Controller and press <Enter>.
Windows Setup
You have chosen to configure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
ENTER=Select F3=Exit
Windows Setup
Setup will load support for the following mass storage device(s):
NVIDIA RAID Driver (required)
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
S=Specify Additional Device Enter=Continue F3=Exit
If a message appears saying one or some file(s) cannot be found, please check the floppy disk
or copy the correct SATA RAID driver again from the motherboard driver disk.
(Note) The selectable item(s) displayed in Figure 3 may differ according to the RAID or AHCI driver
you will install.
GA-M52S-S3P Motherboard
NVIDIA RAID Driver (required)
NVIDIA nForce Storage Controller (required)
Figure 3
Figure 4
- 76 -