Gigabyte GA-M52S-S3P User Manual page 73

After that, the Array List screen appears, displaying the RAID array that you have created (Figure 7).
(Note: BBS stands for BIOS Boot Specification. This indicates that the boot device is defined in the
BIOS.)
Boot
BBS
[Ctrl-X] Exit
To read more information about the RAID array, press <Enter> to enter the Array Detail screen (Figure
8), which shows various information about the array, including the RAID mode, stripe block size, hard
drive model name, and hard drive capacity, etc.
RAID Mode: Striped
Stripe Width : 2
Port Index
1 0
2 1
[R] Rebuild
To clear MBR, press <C> in the Array Detail screen. When the "Clear MBR?" message appears, press
<Y> to clear or <N> to cancel.
To delete the array, press <D> in the Array Detail screen. When the "Delete array?" message appears,
press <Y> to confirm or <N> to cancel. Press <Enter> to return to the Array List screen.
To exit the NVIDIA RAID setup utility, press <Esc> in the main menu or <Ctrl>+<X> in the Array List
screen.
Now, you can proceed to the installation of the SATA controller driver and operating system.
MediaShield Utility Apr 20 2007
- Array List -
Status Vendor
Healthy NVIDIA
[ ] Select [B] Set Boot
Figure 7
Array 1: NVIDIA STRIPE 233.57G
- Array Detail -
Stripe Block: 64K
Disk Model
ST3120026AS
ST3120026AS
[D] Delete [C] Clear MBR
Figure 8
- 73 -
Array Model Name
STRIPE 223.57G
[N] New Array [ENTER] Detail
Capacity
111.79GB
111.79GB
[ENTER] Return
Appendix