Gigabyte GA-K8N Ultra-9 User Manual page 22

9) S_ATA0/1/2/3_SB (SATA 3Gb/s Connectors, Controlled by nForce4 Ultra)
10) SATA0/1/2/3_SII (SATA Connectors, Controlled by Sil3114)
SATA 3Gb/s can provide up to 300MB/s transfer rate while SATA provides up to 150MB/s
transfer rate. Please refer to the BIOS setting for the SATA controller(s)and install the proper
driver in order to work properly.
11) F_AUDIO (Front Audio Panel Connector)
If you want to use Front Audio connector, you must remove 5-6, 9-10 Jumper.
In order to utilize the front audio header, your chassis must have front audio connector. Also please
make sure the pin assigment on the cable is the same as the pin assigment on the MB header. To find
out if the chassis you are buying support front audio connector, please contact your dealer. Please note,
you can have the alternative of using front audio connector or of using rear audio connector to play
sound.
GA-K8N Ultra-9 Motherboard
Pin No.
1
7
S_ATA_SB
(Controlled by nForce4 Ultra)
7
1
SATA_SII
(Controlled by Sil3114)
Pin No.
10 9
1
2
3
2 1
4
5
6
7
8
9
10
- 22 -
Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
Definition
MIC
GND
MIC_BIAS
Power
Front Audio (R)
Rear Audio (R)/ Return R
NC
No Pin
Front Audio (L)
Rear Audio (L)/ Return L