Gigabyte GA-8N775 User Manual page 68

Step 2:
If you do not create RAID, select Hard Disk Boot Priority under the Advanced BIOS Features
menu. In the Hard Disk Boot Priority submenu, select the model of the SATA hard drive onto which
you wish to install Microsoft Windows 2000/XP. You should see a screen similar to Figure 3 below.
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
1. CH2 M. :
2. CH3 M. :
3. Bootable Add-in Cards
: Move PU/PD/+/-: Change Priority
After configuring the SATA controller mode in system BIOS, if you wish to create RAID, save the settings
and exit. Then go to RAID BIOS (refer to (3)Configure RAID set in RAID BIOS section) to configure
the RAID array. After finished, re-enter the system BIOS Setup to set hard disk boot priority before OS
installation. Select Hard Disk Boot Priority under the Advanced BIOS Features menu. In the Hard
Disk Boot Priority submenu, select the RAID array onto which you wish to install Microsoft Windows
2000/XP (Figure 4).
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
1. SCSI-0: NVIDIA MIRROR 111.7
2. Bootable Add-in Cards
: Move PU/PD/+/-: Change Priority
GA-8N775 Motherboard
Hard Disk Boot Priority
ST3120026AS
ST3120026AS
F10: Save
Figure 3
Hard Disk Boot Priority
F10: Save
Figure 4
- 68 -
Item Help
Menu Level
Use < > or < > to
select a device, then
press <+> to move it
up, or <-> to move it
down the list. Press
<ESC> to exit this
menu.
ESC: Exit
Item Help
Menu Level
Use < > or < > to
select a device, then
press <+> to move it
up, or <-> to move it
down the list. Press
<ESC> to exit this
menu.
ESC: Exit