Gigabyte W511 Series User Manual page 18

How to Start
Removing the Battery Pack
To remove the battery pack, slide the related latch and then take out
the battery pack with your finger as the sequence shown in the figure
below.
9
When your W511 series notebook computer estimates that the
battery only has enough charge to continue for a few minutes, it will
alert you with a battery low warning beep. If you are consuming a
lot of power by using the audio system, the PC Card slots, the hard
drives, and optical disk drive, your notebook computer might run out
of charge much sooner than you expect. You should always respond
to the battery low indication by connecting to AC power or turning
off your notebook computer, or suspending to disk. If you do not do
so, the notebook computer will automatically suspend to disk and
turn off. The contents of the memory will store in the hard disk drive.
You will be unable to restart your notebook computer until it has con-
nected to the AC adapter or installed a charged battery. To replace
the battery pack, refer to the previous sections on "Installing the
Battery Pack" and "Removing the Battery Pack."
• Note: Be sure to save your data before replacing the battery
pack or connecting the AC adapter. Failure to do so can result
in data loss.
• Note: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended
by the manufacturer. Dispose of used batteries according to the
manufacturer's instructions.