Sylvania ZV420SL8 Owner's Manual page 36

Checking, canceling, or correcting the timer
programming information
1) Press [T-SET].
will disappear on the front panel display.
2) Press [TIMER PROG.].
3) Check the information on the list you want to edit.
Timer Programming
JAN/ 2/07 12:00 AM 125-1 SP
2H (1:00)
Date Start
JAN/02 12:00AM 1:00AM
New Program
4-A) To delete the timer program:
1 Use [K / L] to select the program you want to
delete, then press [ENTER].
2 Use [K / L] to select "Delete", then press
[ENTER].
Selection menu will appear.
3 Use [K / L] to select "Yes", then press [ENTER].
4-B) To correct the timer program:
1 Use [K / L] to select the program you want to
correct, then press [ENTER].
2 Use [K / L] to select "Program Change", then
press [ENTER].
3 Correct the timer program by using
[K / L / { / B], then press [ENTER].
5) Press [TIMER PROG.] to exit.
6) Press [T-SET] to return to the timer standby mode.
To stop the timer recording in process
Press [STOP C] to stop the disc recording or
[STOP C/EJECT A] to stop the cassette tape recording
on the front panel of the unit.
[STOP C] on the remote control is not effective.
Note
• Press [TIMER PROG.] to check the timer recording in
progress.
When the timer recording is proceeding, that
program will be highlighted with red. In this case,
you cannot select any other program.
36 EN
TIMER RECORDING
MON JAN/01 10:00AM
End L1/L2
L1
1/1
If the timer program did not complete correctly,
the error number appears in the timer pro-
gramming list.
Timer Programming
Date Start
E41 JAN/02 12:00AM 1:00AM
New Program
Each error number means:
E1-22 Recording error other
E37-39 than below
E23-24 Unrecordable disc
E25-28 Copy prohibited program E40
E29 Disc protected
E30 Disc full
E31-32 Already 99 titles
recorded
E33 Already 999 chapters
recorded
E34 No space for Control
information
• A program with the error number is grayed in the timer
programming list.
• Once the timer programming list with error line(s) is
displayed, or after canceling and setting again the timer
standby mode, the program line(s) with error will be
cleared.
*1 PCA is a disc's space reserved for recording test.
TUE JAN/02 10:00AM
End L1/L2
L1
1/1
E35 PCA full *1
E36 Already finalized
video format disc
Some portion has
not been recorded
because of program
overlapping.
Recording did not
start at the start time.
E41 Power failed
E42 No disc when recording