Magnet Mounting - Cisco WS-C3560-48PS-S Hardware Installation Manual

Chapter 3 Switch Installation (8- and 12-Port Switches)

Magnet Mounting

Read the wall-mounting instructions carefully before beginning installation. Failure to use the
Warning
correct hardware or to follow the correct procedures could result in a hazardous situation to people
and damage to the system. Statement 378
Caution Do not wall-mount the switch with its front panel facing up or sideways. According to safety regulations,
magnet-mount the switch with its front panel facing down to improve airflow and to provide easier
access to the cables.
Place one side of the magnet against the bottom of the switch, as shown in
Step 1
Figure 3-7
1
2
Mount the magnet and switch on a vertical metal surface.
Step 2
After the switch is attached to the mounting magnet:
1.
2.
OL-6337-07
Mounting the Switch with a Magnet
3
Metal mounting surface
Mounting magnet
(Optional) Secure the AC power cord. See
Power on the switch. See the
1
3 Switch front panel
"Securing the AC Power Cord" section on page
"Verifying Switch Operation" section on page
Catalyst 3560 Switch Hardware Installation Guide
Installing the Switch
Figure 3-7.
2
3-19.
3-7.
3-15