Connecting Network Devices - Cisco SG 102-24 Quick Start Manual

2

Connecting Network Devices

The application diagram is an example of a typical network configuration.
Link/Act
1 2 3
Gigabit
Link/Act
SYSTEM
13 14 15
Gigabit
To connect the unmanaged rackmount switch to the network:
Connect the Ethernet cable to the Ethernet port of a computer,
S 1
TEP
printer, network storage, or other network device.
Connect the other end of the network Ethernet cable to one of the
S 2
TEP
numbered unmanaged rackmount switch Ethernet ports.
The LED of the port lights if the device connected is active.
If the uplink from one unmanaged, cascaded switch to another is
N
OTE
moved from one port to another port, it can take up to one minute
for full network operation to resume. This is normal and expected
behavior.
Repeat
S 3
TEP
the unmanaged rackmount switch.
To prioritize voice or video traffic by using the QoS feature on the
N
OTE
switch, set flow control to off in the configurations of the
connected devices. Otherwise, flow control might send a pause
Cisco Unmanaged Rackmount Switches
1 2
4 5 6 7 8 9 10 11 12 / miniGBIC1
16 17 18 19 20 21 22 23 24 / miniGBIC2
13 14
Step 1 and Step 2
3 4 5 6 7 8
15 16 17 18 19 20
for each device you want to connect to
9 10 11 12
(Shared with 12) (Shared with 24)
21 22 23 24 miniGBIC1 miniGBIC2
Cisco Small Business
SR2024
24-Port
10/ 100/ 1000 Swit ch
5