Cisco EF4116 Hardware Installation And Maintenance Manual page 73

At the prompt, specify the channel-group modification command, channel-group and
Step 6
timeslots to be mapped. The example shows channel-group 0 and timeslots 1, 3 through 5,
and 7 selected for mapping.
Router(config-controller)# channel-group 0 timeslots 1,3-5,7
Router(config-controller)#
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1:0, changed state to down
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1:0, changed state to up
Router(config-controller)#
Router(config-controller)#
At the prompt, specify the interface, serial, unit number, and channel-group to modify.
Step 7
Router(config-controller)# int serial 1:0
At the prompt, assign an IP address and subnet mask to the interface with the ip address
Step 8
configuration subcommand as in the following example:
Router(config-if)# ip address 1.1.15.1 255.255.255.0
Router(config-if)#
Add any additional configuration subcommands required to enable routing protocols and
Step 9
adjust the interface characteristics.
After including all of the configuration subcommands, to complete the configuration, enter
Step 10
^Z (hold down the Control key while you press Z) to exit the configuration mode.
Write the new configuration to memory as follows:
Step 11
Router# write memory
The system will display an OK message when the configuration is stored.
Exit the privileged level and return to the user level by entering disable at the prompt as
Step 12
follows:
Router# disable
Router>
Check the interface configuration with show commands.
Step 13
Refer to the printed Router Products Configuration Guide and Router Products Command Reference
publications or UniverCD for a summary of the configuration options available and additional
instructions for configuring the CT1 module.
Making Network Connections
Installing the Router 3-15