Details Of The Password Recovery Procedure - Cisco 7206 - VXR Router Installation Manual

Chapter 5 Maintaining the Cisco 7206
Recover or replace the displayed passwords.
Step 7
Change the configuration register back to its original setting.
Step 8
Note To recover a lost password if the Break function is disabled on the router, you must have physical access
to the router.

Details of the Password Recovery Procedure

Complete the following steps to recover or replace a lost enable, enable secret, or console login
password:
Attach an ASCII terminal to the console port on your Cisco 7206.
Step 1
Configure the terminal to operate at 9600 baud, 8 data bits, no parity, and 2 stop bits.
Step 2
If you can log in to the router as a nonprivileged user, enter the show version command to display the
Step 3
existing configuration register value. Note the value for use later and proceed to
log in to the router at all, go to the next step.
Press the Break key or send a Break from the console terminal. If Break is enabled, the router enters the
Step 4
ROM monitor, indicated by the ROM monitor prompt (
power cycle the router (turn the router off or unplug the power cord, and then restore power). Then
proceed to Step 5.
Step 5 Within 60 seconds of restoring the power to the router, press the Break key or send a Break. This action
causes the router to enter the ROM monitor and display the ROM monitor prompt (
Step 6 Set the configuration register using the configuration register utility; enter the confreg command at the
ROM monitor prompt as follows:
rommon1> confreg
Answer yes to the enable "ignore system config info?" question and note the current configuration
register settings.
Step 7 Initialize the router by entering the reset command as follows:
rommon2> reset
The router initializes the configuration register that is set to 0x142, and the router boots the system image
from Flash memory and enters the system configuration dialog (setup) as follows:
--- System Configuration Dialog --
Enter no in response to the system configuration dialog prompts until the following message is
Step 8
displayed:
Press RETURN to get started!
Press Return. The user EXEC prompt is displayed as follows:
Step 9
Router>
Enter the enable command to enter privileged EXEC mode. Then enter the show startup-config
Step 10
command to display the passwords in the configuration file as follows:
Router# show startup-config
OL-5102-02
Replacing or Recovering a Lost Password
). Proceed to Step 6. If Break is disabled,
rommon1>
Cisco 7206 Installation and Configuration Guide
Step 6. If you cannot
).
rommon1>
5-15