Cisco 2651 User Manual page 32

The Cisco 1721, 1760, 2621XM, 2651XM, 2691, 3725, 3745, and 7206 VXR NPE-400 Routers
Place the seventh label on the router as shown in
Step 8
so that one half of the label covers the enclosure and the other half covers the Compact Flash slot. Any
attempt to remove a CF card will leave tamper evidence.
Step 9 The labels completely cure within five minutes.
Figure 22
NM -HD
V
BA NK 4
BA NK 3
BA NK 2
To apply tamper-evidence labels to the Cisco 3725:
Clean the cover of any grease, dirt, or oil before applying the tamper evidence labels. Alcohol-based
Step 1
cleaning pads are recommended for this purpose. The temperature of the router should be above 10°C.
Step 2 Place the first label on the router as shown in
that the one half of the tamper evidence label covers the enclosure and the other half covers the right side
of the router. Any attempt to remove the enclosure will leave tamper evidence.
Step 3 Place the second label on the router as shown in
so that the one half of the tamper evidence label covers the enclosure and the other half covers the left
side of the router. Any attempt to remove the enclosure will leave tamper evidence.
Place the third label on the router as shown in
Step 4
that the one half of the label covers the enclosure and the other half covers the top double-sized Network
Module slot. Any attempt to remove a network module will leave tamper evidence.
Place the fourth label on the router as shown in
Step 5
so that the half of the label covers the enclosure and the other half covers the bottom Network Module
slot. Any attempt to remove a network module will leave tamper evidence.
Place the fifth label on the router as shown in
Step 6
that one half of the label covers the enclosure and the other half covers the left WAN interface card slot.
Any attempt to remove a WAN interface card will leave tamper evidence.
Place the sixth label on the router as shown in
Step 7
that one half of the label covers the enclosure and the other half covers the middle WAN interface card
slot. Any attempt to remove a WAN interface card will leave tamper evidence.
Cisco 1721, 1760, 2621XM, 2651XM, 2691, 3725, and 3745 Modular Access Routers and 7206-VXR NPE-400 Router FIPS 140-2 Non-Proprietary
32
Tamper Evidence Label Placement
BA NK 1
BA NK 0
V0 SEE MAN
UAL BEF
ORE INST DSU
EN ALLA TION 56K
SEE MAN
UAL BEF
ORE INST
ALLA TION
Figure 22. The tamper evidence label should be placed
DSU
56K
SEE MAN
UAL BEF
ORE INST
ALLA TION
SE RI ES
SE RI ES
Figure 23. The tamper evidence label should be placed so
Figure 23. The tamper evidence label should be placed
Figure 23. The tamper evidence label should be placed so
Figure 23. The tamper evidence label should be placed
Figure 23. The tamper evidence label should be placed so
Figure 23. The tamper evidence label should be placed so
OL-6083-01