E-Mu 1212M Quick Start Manual page 15

Digital audio systems
Hide thumbs Also See for 1212M:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
EMU QS(En).fm Page 15 Thursday, October 26, 2006 11:09 AM
Six balanced 24-bit, line-level, analog outputs are provided (Stereo 1-3). Output pair 1 is
designated as the Monitor Output and is normally fed by the monitor output of the PatchMix DSP
mixer application. All the analog outputs can be freely assigned in the mixer application.
Special anti-pop circuitry mutes the analog outputs when power is turned on or off.
Line Level
Analog
Like the analog line inputs, either TRS balanced or TS unbalanced cables can be used.
Outputs
Balanced cables provide better noise immunity and +6dB higher signal level, but standard mono
instrument cables also work well.
The output line level can be set to accommodate the consumer -10 dBV standard, or the pro audio
+4 dBu standard in the I/O screen of the Session Settings dialog box.
The RCA turntable inputs feed an RIAA equalized phono preamp designed to accept moving
Turntable
magnet type phono cartridges. The turntable inputs share line level inputs 2L and 2R. Inserting a
Inputs &
plug into Line Input 2 disconnects the phono preamp from that channel. Connect the ground lead
Ground Lug
from your turntable to the turntable ground lug to prevent hum.
Attach the supplied MIDI Breakout cable to the MIDI Port connector on the rear of the MicroDock.
MIDI input and output ports allow you to interface any type of MIDI equipment such as keyboards,
MIDI 1& 2
effect units, drum or guitar controllers. The MIDI drivers were installed when you installed your
In/Out
Patchmix DSP software and the MIDI ports will appear in your system control panel under "Sounds
and Audio Devices".
These stereo mini-phone (3.5mm) jacks duplicate the line level outputs 1-3. These line level
Alternate
Outputs
outputs are designed for easy interface to powered computer speakers.
Connects the MicroDock to the E-MU 1010 PCI card using CAT 5e type computer cable. The cable
EDI Connector
supplied with the MicroDock is specially shielded to prevent unwanted RF emissions.
Quick Start Guide - Getting Started - 15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

1616m16161616m pci

Table of Contents