Playback - Denon AVR-2312CI Owner's Manual

Playback

1
ZONE SELECT
Press to switch the
zone mode to K (ZONE2).
2
Press AMP to set the remote
control unit to AMP-operation
mode.
3
Press ZONE/DEVICE Z to turn on
the ZONE2 power.
The indicator on the display lights.
• Also press input source select button when
in standby mode, the power turns on.
ZONE/DEVICE X
• When is pressed, ZONE2
turns off.
• Power in ZONE2 can be turned on or off by
ZONE2 ON/OFF
pressing on the main unit.
4
Press the input source select
button.
The audio signal of the selected source
is output to ZONE2.
• To perform an operation with the main unit, press
SELECT
many times.
When power for both MAIN ZONE and ZONE2 is set to ON, power of
the MAIN ZONE only can be turned off. Select
ZONE/DEVICE X
step 1 then press .
BD
Adjusting the volume
M df
Use to adjust the volume.
GAdjustable rangeH – – –
(When the "Volume Display" (vpage 113) setting is "Relative")
GAdjustable rangeH
(When the "Volume Display" (vpage 113) setting is "Absolute")
Input source
• At time of purchase, "Volume Limit"
select buttons
"–10dB (71)".
MASTER VOLUME
Turn
main unit to adjust the sound volume.
Turning off the sound temporarily
N
Press .
The sound is reduced to the level set at "Mute Level" (vpage 112)
in the menu.
• To cancel, either adjust the volume or press
ZONE2 / REC
• The setting is canceled when the zone's power is turned off.
You can adjust the tone and volume for ZONE2 in "ZONE2 Setup"
(vpage 112) in the menu.
J
(MAIN ZONE) in
–80dB – –40dB – 18dB
0 – 41 – 99
(vpage 112) is set to
ZONE2 / REC SELECT
after pressing on the
N
again.
vSee overleaf
80