Installation; Using For The First Time - DeLonghi Magnifica ESAM6600 User Manual

3 INSTALLATION

• After removing the packaging, make sure the product is complete and undamaged. If in doubt, do not use
the appliance and contact a qualified professional.
• Packing elements (plastic bags, polystyrene etc.) must not be left within reach of children as they may rep-
resent a hazard.
• Place the appliance on a work surface far away from water taps, basins and sources of heat.
• After positioning the appliance on the work top, leave a space of at least 2 in. (5 cm) between the sur-
faces of the appliance and the side and rear walls and at least 8 in. (20 cm) above the coffee maker.
• Never install the appliance in environments where the temperature may reach freezing or below
freezing temperatures (the appliance could be damaged if the water freezes).
• Make sure the mains voltage corresponds to the voltage indicated on the appliance rating plate. Connect
the appliance to a grounded socket with a minimum current rating of 10amps. The manufacturer is not
liable for possible accidents caused by failure to do so.
• If the power socket does not match the plug on the appliance, have the socket replaced with a suitable
type by a qualified professional.
• The power cable on this appliance must not be replaced by the user as this operation requires the use of
special tools. If the cable is damaged or requires replacing, contact an authorized service center only to
avoid all risks.
• You should personalize water hardness as soon as possible following the instructions in section 17.6.
• Coffee has been used to factory test the appliance and it is therefore completely normal for there to be
traces of coffee in the mill. This appliance is, however, guaranteed to be new.
To learn how to operate the appliance correctly, when you use it for the first time, follow the step-by-step
instructions given in the following sections.

4 USING FOR THE FIRST TIME

1. The first time you use the appliance, select the language.
To set English, plug the appliance into the outlet and wait for the appliance to display:
Press the OK button (fig. 1) for at least three seconds until you hear a BEEP and the display shows:
The appliance then displays the setting message in English. If you select the wrong language by mistake,
follow the instructions in section 18 to choose the right one.
2. After 5 seconds, the appliance displays:
To fill, remove the water tank (fig. 2), rinse and fill with fresh water. Never exceed the MAX line.
Put the water tank back and push as far as it will go.
3. Place a cup under the hot water spout (fig. 3). If the water spout is not in place, INSERT WATER SPOUT is dis-
played. Attach it as shown in figure 4; making sure the arrow on the spout is lined up with the arrow on
the control panel of the appliance, (fig. 4). The appliance now displays:
4. Press the OK button (fig. 1). A little water will run from the spout (running water stops automatically).
5. The appliance now displays:
and it goes off.
6. Fill the container with coffee beans (fig. 5), being careful not to exceed the MAX line.
IMPORTANT: To prevent malfunction, never fill with ground coffee, freeze dried coffee, caramelized beans
or anything else which could damage the appliance.
C o l l e c t i o n
PRESS OK TO INSTALL ENGLISH
ENGLISH INSTALLED
FILL TANK
PRESS OK
TURNING OFF PLEASE WAIT...
9