Sample Setup For Terminal Mode - Dell 3250 Product Manual

Sample Setup for Terminal Mode

The following is an example of how to configure the console/host and server for Terminal Mode.
In this example, the console is running Windows 2000 with SP3. The console and server are
directly connected through the serial ports of both systems. See Serial/Modem Channel
Configuration Sub-task for details about the Serial / Modem configuration screens.
Server Configuration
1. Run the SMU to configure the BMC.
2. In the Navigation Pane at the left side of the SMU, click Serial/Modem to go to the
Serial/Modem configuration menu.
3. At the Connection Mode box, pull down the menu and select Direct Connect Mode.
4. Select Always Available for the Access Mode.
5. Select Administrator for the Privilege Level Limit.
6. Select None for Flow Control.
7. Leave the Enable Data Terminal Ready box unselected.
8. Select 19200 for the Baud Rate.
9. Click Next to move to the next menu.
10. Click Next again to reach the Terminal Mode Configuration screen.
11. Click in the Enable Terminal Mode box to select it.
12. Click in the Enable Line Editing box to select it.
13. Select Backspace for the Delete Control.
14. Select the box for Turn BMC echo of received characters on.
15. Select the box for Enable handshake when BMC ready to receive another message box.
16. Select CRLF for the Newline output sequence (BMC to console) box.
17. Select CR for the Newline input sequence (console to BMC) box.
18. Click Save to save your settings and click OK to return to the Home page of the SMU.
19. Click on the User option in the Navigation Pane to configure the user setup.
20. Select the Anonymous User box and click on the Edit button to configure this user.
21. In the Edit User Configuration screen, check the Enable User box.
22. In the Enter New Password box, enter your password. In this example the password is
guest.
23. Enter the password again in the Verify New Password box.
24. Select Administrator for the User Privilege Level under the Serial/Modem Channel menu.
25. Click OK to exit out of this menu.
26. Click Save to save the configuration.
27. Click OK at the User Save Result menu to return to the Home menu.
28. At the Home menu, click on the Exit option in the Navigation pane to exit SMU.
29. Click OK to confirm the exit.
30. Reboot the server.
147