Using Your Projector; Turning Your Projector On; Turning Your Projector Off - Dell 4320 User Manual

Using Your Projector

Turning Your Projector On

NOTE:
Turn on the projector before you turn on the source (computer, DVD
player, etc.). The Power button light blinks blue until pressed.
Remove the lens cap.
1
Connect the power cord and appropriate signal cables to the projector. For
2
information about connecting the projector, see "Connecting Your Projector" on
page 10.
Press the Power button (see "Using the Control Panel" on page 31 to locate the
3
Power button).
Turn on your source (computer, DVD player, etc.)
4
Connect your source to the projector using the appropriate cable. See
5
"Connecting Your Projector" on page 10 for instructions to connect your source to
the projector.
By default, the input source of the projector is set to VGA-A. Change the input
6
source of the projector if necessary.
If you have multiple sources connected to the projector, press the Source button
7
on the remote control or control panel to select the desired source. See "Using the
Control Panel" on page 31 and "Using the Remote Control" on page 33 to locate
the Source button.

Turning Your Projector Off

CAUTION:
the following procedure.
Press the Power button. Follow the instruction displayed on screen to properly
1
turn off the projector.
NOTE:
The "Press Power Button to Turn off Projector" message will
appear on the screen. The message disappears after 5 seconds or you can
press the Menu button to clear it.
Press the Power button again. The cooling fans continue to operate for 120
2
seconds.
24 Using Your Projector
Unplug the projector after properly shutting down as explained in
3