Configure Wep In Bridge Mode - D-Link DAP-1555 User Manual

Section  - Security
It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please
establish wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption
due to the added overhead.
1. Log into the web-based configuration by opening a web browser and entering the IP address of the bridge
(192.168.0.35). Click on Setup and then click Wireless Settings on the left side.
2. Next to Security Mode, select WEP.
3. Next to WEP Key Length, select the level of encryption (64
or 128-bit).
Hex - (recommended) Letters A-F and numbers 0-9
are valid.
4. Next to WEP Key, enter a WEP key that you create.
Make sure you enter this key exactly on all your wireless
devices.
5. Next to Authentication, select Open or Shared Key.
6.Click Save Settings to save your settings. If you are
configuring the access point with a wireless adapter, you will
lose connectivity until you enable WEP on your adapter and
enter the same WEP key as you did on the access point.
D-Link DAP-1555 User Manual

Configure WEP In Bridge Mode