Defining Stp On Interfaces - D-Link xStack DXS-3250E Web/Installation Manual

DXS-3227, DXS-3227P, DXS-3250 and DXS-3250E EWS User Guide

Defining STP on Interfaces

Network administrators can assign STP settings to specific interfaces using the STP Interface Page. To assign
STP settings to an interface:
1. Click Advanced Setup > Spanning Tree > STP > Interface Settings. The STP Interface Page opens:
Figure 158:STP Interface Page
The STP Interface Page contains the following fields:
To display STP Interface settings, select a Unit number:
•
Unit No. — Indicates the stacking member for which the Spanning Tree interface information is displayed.
STP Interface Table
In addition to the field above, the following fields appear in the STP Interface Table:
•
Port — The interface for which the information is displayed.
•
STP — Indicates if STP is enabled on the port. The possible field values are:
–
Enabled — Indicates that STP is enabled on the port.
–
Disabled — Indicates that STP is disabled on the port.
Page 230