Using Additional Handsets; Registering An Additional Handset - Motorola D511 User Manual

9. Using additional handsets

You can register up to five handsets to your D5 base to
extend your phone system without having to install extension
sockets for each new phone.
Each D5 handset can be registered with up to four bases.
You can then select the base you prefer to use.
If you have purchased a D5 multiple pack, all additional
handsets come pre-registered to the base.
If you have purchased an additional handset separately, you
must register it to your D5 base before it can be used.
9.1

Registering an additional handset

NOTE
Handset batteries must be fully charged before you start to
register. Hold your handset close to the base during the
registration process.
Handsets that were supplied with your D5 base are already
pre-registered.
On the base:
p
1. Press and hold the
hear two beeps. The base will remain in registration
mode for 90 seconds.
28
button for 3 seconds until you
On the handset:
m d
1. Press , scroll to
d
REG BASE
2. Scroll to and press
3. Enter the base number (1 - 4).
The base numbers that are already in use flashes. The
SEARCHING...
display shows
4. When the handset finds the base signal, the display
SEARCHING...X
shows , where
identification number.
5. The display will ask for the PIN to be entered. Enter the
4 digit PIN code (default = 0000) and press
You will hear a beep if the registration is successful.
The handset is automatically assigned an available
handset number. Use this number when making
internal calls.
NOTE
If registration is not successful the first time, please repeat
the process again in case the base registration period ran
out of time. If the base is not found after a few seconds, the
handset returns to standby. Try registering again.
If there are already 5 handsets registered to the base, the
registration will fail. You must de-register another handset
before you can register a new one.
m
REGISTER
and press .
m
.
.
X
indicates the base
m
Using additional handsets
.