Record Snapshots To Your Ftp Server With Motion Detection - D-Link SECURICAM NETWORK DCS-5300 User Manual

Record Snapshots to your FTP
server with Motion Detection
Administrators can combine options on the application page to perform many
useful security tasks. There are two trigger sources available: from an external
sensor or with built-in motion detection. There are also two kinds of actions
that can respond to these events that include uploading snapshots over the
internet and driving attached devices. To upload the snapshots, users can choose
either email or FTP according to user's needs. Both e-mail and FTP use the
network settings on the network page. This section describes how to enable
motion detection and record snapshots to an FTP server.
If no external sensor is available, administrators can utilize the built-in motion
detection to monitor any abnormal movement and then record the snapshots
to an FTP or SMTP server.
Click the Motion Detection button under the Advanced tab from the
Configuration screen to access settings that affect how the DCS-5300 Internet
Camera can serve as a security device by recording only when motion is
detected.
Click Motion Detection
In this window, follow the steps below to ensure that motion detection is correctly
enabled:
Check "Enable motion detection."
Click on "New" to have a new window to monitor video.
Enter in a window name.
Adjust the "Sensitivity" and "Percentage" levels according to the local
environment. The highest sensitivity and lowest percentage provides
the most sensitive setting.
5 5 5 5 5 Click on save to enable the activity display.
62