Erasing An Entire Song; Saving Your Song; Append A Song; Name A Song (Name) - Akai XR 20 Reference Manual

ERASING AN ENTIRE SONG

1. The XR20 should be in Song Mode.
2. Use the number buttons, INC / DEC buttons or the
VALUE dial to select the Song to be erased.
3. Press and hold the ERASE button. You will see the
screen shown on the right.
4. While holding down the ERASE button, press REC
(DO IT). The display says SONG ERASED and
erasure is complete.
5. Release the ERASE and REC (DO IT) buttons.

SAVING YOUR SONG

When you are finished putting together your Song, you will need to save it to permanent memory.
Please note that all Song data will be lost if you turn off the XR20 before saving your Song.
1. The XR20 should be in Song Mode.
2. Use the INC / DEC buttons, the number keypad or the
VALUE dial to select the Song which you would like to
save.
3. Press and hold the SAVE / COPY button.
4. Press REC (DO IT) to save the song. The display will
show SAVE DONE.
5. Release the SAVE / COPY button.

APPEND A SONG

You can use this feature to append all content from the selected Song to the end of another
Song. Appending a Song to an empty destination will create an identical copy of the Song. Note
that you can double the Song sequence by appending a Song to itself.
1. The XR20 should be in Song Mode.
2. Select the Song to be copied to itself with the number buttons, INC / DEC buttons or the VALUE
dial.
3. Press and hold the SAVE / COPY button.
4. While holding the SAVE / COPY button, press the
PAGE RIGHT button. You will see the screen shown
on the right.
5. While continuing to hold the SAVE / COPY button,
enter the same Song number as the one selected in
step (2).
6. Press REC (DO IT) to copy the song to itself.
7. Release the SAVE / COPY and REC (DO IT) buttons.

NAME A SONG (NAME)

1. Press RECORD SETUP. If the Song has been named, the name will show on the top line. If the
Song has not been named, the display says NO NAME.
2.
Enter the name using the PAGE RIGHT/LEFT buttons to select the character to be changed
(selected character is indicated by a cursor underneath it), and the INC/DEC buttons or Value Dial
to select the desired character. Lower case and upper case letters, numbers, punctuation, and
various special-purpose characters are available. You can also enter numbers with the number
buttons.
44