Table of Contents
Advertisement
2.2 Remote Overview
The GRC-815 remote control is a pre-
programmed remote control that has
been designed specifically to work
with the GDV-850 DVD player. While
a disc is spinning up and playing the
opening title sequences, some func-
tions may be non-functional.
NOTE: A hand icon is displayed when
a button press is not a valid operation
accepted by the unit for the disc you
are playing.
Alkaline batteries are recommended
for maximum operating life. Two AAA
(R 03) batteries should be fitted into
the battery compartment at the rear
of the remote control. When replacing
batteries, check that they have been
put in correctly, as indicated in the
battery compartment.
Remote Features
[ 25 ] Power Button
This button turns the DVD player on
from a standby state. The main power
switch on the rear panel must be in the
on position for this button to function.
[ 26 ] Setup Button
Pressing the setup button enters the
setup OSD menu for the DVD player
itself. Setup is covered in the next
section of this manual. Some setup
procedures will not be available when
a media disc is active. Pressing the
setup button again will exit the menu
and all changes will be saved.
[ 27 ] Video Format Button
This button cycles the video out-
put format of the GDV-850 between
NTSC and PAL. NTSC is used in North
America and in many other countries.
PAL is used mainly in Europe and some
Asian countries. You should not have
to adjust this feature. If you hit this
button by mistake and your picture is
changed, then simply hit the button
again to restore the picture.
[ 28 ] Eject Button
Pressing this button open/closes the
disc tray.
[ 29 ] Direct Access Keypad
A direct access keypad can be used in
the setup and operation of the DVD
player. For instance the keypad is used
to enter passwords in the setup menu
and can also be used to navigate to
particular chapters on the disc.
[ 30 ] Clear Button
The clear button can be used to erase
the numerical value entered with the
keypad and to exit/step back in the
setup menu. During playback of CDs
and MP3s hitting the clear button will
activate the graphic EQ circuitry. See
section 4.7 for more information.
[ 31 ] Play Back Control Button
The PBC button turns playback control
off and provides direct access to the
individual titles on a DVD. Pressing
this button brings up a separate
menu to navigate and play each title.
Information about each title is also
displayed in this menu. Different areas
of this disc can be navigated with the
navigation and select buttons. This
function may not be available on all
discs. To exit the menu press the PBC
button once again. Playback control
will resume and the ADCOM DVD player
title page will be displayed.
[ 32 ] Repeat 1/all Button
The repeat 1/all button sets the
option to repeat either the current
track or repeat all tracks on an audio
based disc, DVD-Audio, CD, etc. When
a DVD video disc is playing this but-
ton will first bring up the option to
repeat the current chapter (repeat
1), and secondly when pressed will set
the option to repeat the tile (entire
movie). Pressing this button a third
time when playing a DVD video disc
will exit the repeat option.
[ 33 ] Repeat A-B Button
The repeat A-B button will set a loop-
ing playback from any starting point
in a track/chapter that you select to
an ending point that you define. Press
this button once to set the first point
of reference (A), then press it again
to set your ending point (B). To cancel
this playback loop, press the repeat A-
B button a third time.
[ 34 ] Go To Button
The go to button works in conjunction
with the direct access keypad and the
navigation and select buttons. When
pressed, an overlay will appear in the
upper portion of the display and you
will first have the ability to enter a
particular chapter/track to jump to.
The option to navigate to a different
title is also available. To do this use
the left and right navigation buttons to
highlight the title. Use your key pad to
enter the number of the title. To jump
to a specific time press the go to but-
ton again and the display will change,
allowing you to enter a desired time.
Press the select button after you have
made your choice.
[ 35 ] Audio Button
Pressing the audio button will cycle
through the available audio formats
available on the disc. Often times
you can choose from 2.0 channel, 5.1
channel, different languages and dif-
ferent encoding formats.
ADCOM GDV-850 Owner's Manual |
13
Advertisement
Table of Contents
