10Mbps Ports; Cable Types - D-Link DES-810 User Manual

Switch. When connecting a workstation or a server running at 100Mbps, a
standard 100BASE-TX adapter must be installed. When running at 10Mbps,
ports 1 and 2 are functionally identical to the 10Mbps ports described below.

10Mbps Ports

These ports require Category 3, 4, or 5 unshielded twisted-pair or shielded
twisted-pair (UTP/STP) cable. They can be used to connect to individual
workstations, servers or other 10BASE-T devices. The attached station must
be within 100 meters of the 10/100 Fast Ethernet Switch. When connecting a
workstation or a server, a standard 10BASE-T adapter must be installed.

Cable Types

Under most conditions, the ports on the 10/100 Fast Ethernet Switch may use
normal straight-through cables. Some circumstances, however, may require
the use of crossover cables (i.e., cables in which the twisted-pair outputs have
been crossed). See Appendix B for more information on crossover cable
pinouts. The table below describes when to use which cable type.
16 Installation