Keyboard Wedge Ms1690-47 - Metrologic MS1690 - Focus - Wired Handheld Barcode Scanner Installation And User Manual

Area imaging bar code scanner
Hide thumbs Also See for MS1690 - Metrologic Focus - Wired Handheld Barcode Scanner:
Table of Contents

Advertisement

I
NSTALLING THE

Keyboard Wedge MS1690-47

1.
Turn off the host device.
2.
Plug the 10-pin RJ45 male end of the
PowerLink cable into 10-pin socket on
the Focus. You will hear a 'click' when
the connection is made.
3.
Disconnect the keyboard from the host
device.
4.
Connect the "Y" ends of the
communication cable to the keyboard
and keyboard port on the host device.
If necessary use the male/female
adapter cable supplied with the scanner
for proper connections.
5.
Plug the external power supply (required)
into the power jack on the PowerLink cable.
Check the AC input requirements
of the power supply to make sure the
voltage matches the AC outlet. The
outlet must be located near the
equipment and be easily accessible.
6.
Connect AC power to the transformer.
7.
Focus will start to initialize. All LEDs (yellow, white, and blue) will light for
approximately 2 seconds then start to alternately flash. When the scanner
has finished initializing the LEDs will stop flashing and the unit will beep
3 times indicating that the scanner is ready for use.
8.
Turn on the host device.
Plugging the scanner into a port on the host system does not guarantee that
scanned information will be communicated properly to the host system. The
scanner is shipped from the factory configured with default settings. Please
refer to the MetroSelect Single-Line Configuration Guide (
MetroSet2's help files for instructions on changing the scanner's
configuration. In addition, please check that the scanner and host system
are using the same communication protocol.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must
meet the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 60950.
To maintain compliance with standard CSA-C22.2 No. 60950-00/UL 60950 and norm EN/IEC
60950, the power source should meet applicable performance requirements for a limited
power source.
8
S
CANNER TO THE
H
S
OST
YSTEM
Figure 7.
00-02544) or
MLPN

Advertisement

Table of Contents
loading

Table of Contents