Other Programming Selections; Data Format Editor Commands - Honeywell 3800gPDF - Hand Held Decoding Linear Imager User Manual

inside back cover to program the imager for your terminal ID (you must
enter 3 digits). For example, scan 0 0 3 for an AT wedge.
Note: The wildcard for all terminal types is 099.
Step 4. Code I.D.
In Appendix A
format. Locate the Hex value for that symbology and scan the 2 digit
hex value from the
manual.
Step 5. Length
Specify what length (up to 9999 characters) of data will be acceptable
for this symbology. Scan the four digit data length from the
ming Chart
is entered as 0050. 9999 is a universal number, indicating all lengths.)
Step 6. Editor Commands
Refer to the Format Editor Commands Chart
symbols that represent the command you want to enter. 94 alphanu-
meric characters may be entered for each symbology data format.
Step 7. Scan Save from the
manual to save your entries.

Other Programming Selections

• Clear One Data Format
This deletes one data format for one symbology. If you are clearing the
primary format, scan 0 from the
this manual. If you are clearing an alternate format, scan 1, 2, or 3, depending
on the alternate format you are clearing. Scan the Terminal Type (refer to the
Supported Terminals Chart on
Chart on page A-1), and the bar code data length for the specific data format
that you want to delete. All other formats remain unaffected.
• Save from the
This exits, saving any Data Format changes.
• Discard from the
This exits without saving any Data Format changes.

Data Format Editor Commands

Send Commands
F1 Send all characters followed by "xx" key or function code, starting from cur-
rent cursor position. Syntax = F1xx (xx stands for the hex value for an
ASCII code, see
F2 Send "nn" characters followed by "xx" key or function code, starting from
current cursor position. Syntax = F2nnxx (nn stands for the numeric value
5 - 2
find the symbology to which you want to apply the data
Programming Chart
inside the back cover of this manual. (Note: 50 characters
Programming Chart
page
Programming Chart
Programming Chart
ASCII Conversion Chart (Code Page 1252)
inside the back cover of this
inside the back cover of this
Programming Chart
2-2), Code I.D. (refer to the
inside the back cover of this manual
inside the back cover of this manual
Program-
(page 5-2). Scan the
inside the back cover of
Symbology
on page A-3.)