Miele T 7634 Operating Instructions Manual page 14

How to dry correctly
F Start the programme
The Start/Stop button will flash when a
programme is being selected. The
flashing indicates that a programme
can be started.
^ Press the Start/Stop button.
The Start/Stop button will now light up
constantly.
Drying will appear in the display and
the time remaining will start counting
down.
Memory
Settings selected for a programme can
be stored in memory, so that they are
automatically selected when this
programme is chosen again. See
"Programmable functions - Memory
function".
Before the end of a programme
There is a cooling down phase at the
end of the drying sequence ( Cooling
down will light up in the display). The
programme will not finish until the
cooling down phase has been
completed.
There is no cooling down phase at the
end of the following programmes:
Woollens handcare, Smoothing.
14
G Remove the laundry when the
programme has finished
0 and Finish will appear in the display
to indicate that the programme has
finished. The buzzer (if selected) will
sound at intervals.
The drum will continue to rotate at
intervals to prevent laundry creasing,
if you do not wish to remove it
immediately (anti-crease). The
anti-crease phase lasts for an hour.
There is no anti-crease phase at the
end of the Woollens handcare
programme.
^ Press the Door button.
^ Open the door.
^ Remove the laundry.
Check that all items have been
removed from the drum. If items are
left in the dryer, they could be
damaged by overdrying when the
dryer is next used.
If the dryer is switched on at the mains
and the door is opened, the drum
lighting will come on. It will go out a few
minutes later to save energy.
^ Switch the dryer off by pressing the
l-On/0-Off button.
^ After every cycle, remove the fluff
from the fluff filter in the door.
^ Close the door.