Destination Port - D-Link DSL-G684T User Manual

Click the Apply button to put the new rule into effect. Any filter rule configured in the menu will appear in the Filters
List with the new settings. The Router must save the new settings and reboot before the new rules are applied.
Filters Parameter
Source IP
Destination IP
Source Port

Destination Port

Protocol
Action
DSL-G684T Wireless ADSL Router User Guide
Description
For an Outbound Filter, this is the IP address or IP addresses on your LAN
for which you are creating the filter rule. For an Inbound Filter, this is the
IP address or IP addresses for which you are creating the filter rule. You
can opt to indicate a
menu. Choosing Any IP will apply the rule to all WAN or all LAN IP
addresses depending on which type of rule (Inbound or Outbound) is being
configured.
Where the Destination IP address resides also depends on if you are
configuring an Inbound or Outbound filter rule. You can opt to indicate a
Single IP IP Range
, an
The Source Port is the TCP/UDP port on either the LAN or WAN depending
on if you are configuring an Outbound or Inbound Filter rule. Select one of
the following options from the pull-down menu to define
Port Port Range
, or
The Destination Port is the TCP/UDP port on either the LAN or WAN
depending on if you are configuring an Outbound or Inbound Filter rule.
Select one of the following options from the pull-down menu to define a
Any Port, Single Port
Select the transport protocol (
the filter rule.
Allow Deny
Select to or
criteria defined in the rule. Packets that are allowed are routed to their
destination; packets that are denied are blocked.
Single IP IP Range
, an
Any IP
or from the pull-down menu.
Safe Range
(ports above 1024).
Port Range Safe Range
, or
TCP UDP
, or
transport of the data packets according to the
17
Any IP
or from the pull-down
Any Port, Single
(ports above 1024).
TCP/UDP
) that will be used for