Zone 2; Connecting Zone 2 Components - Yamaha R-S700BL Owner's Manual

Connecting Zone 2 components

This unit allows you to configure a multi-room audio system. The Zone 2 feature enables you to set this unit to reproduce
separate input sources in the main room and in Zone 2 (the second room) simultaneously. You can control this unit from
the second room using the supplied remote control.
The R-S700 can also be operated using the supplied Zone 2 remote control.
You need the following additional equipment to use the multi-room system of this unit:
• An infrared signal receiver for the second room.
• An infrared emitter for the main room. This emitter transmits the infrared signals sent by the remote control in Zone 2
to the components in the main room.
• An amplifier and speakers for the second room.
y
Some Yamaha models are able to connect directly to the REMOTE OUT jack on the rear panel of this unit. If you own one of these
products, you may not need to use an infrared emitter. Up to six Yamaha components can be connected as shown below.
REMOTE
IN
Infrared signal
receiver
■ Multi-room configuration and connections
The following illustration shows an example of a multi-room system configuration and connections.
CD changer
(or other components)
y
Since there are many possible ways to connect and use this unit in a multi-room configuration, we recommend that you consult with
your nearest authorized Yamaha dealer or service center for the Zone 2 connections that best meet your requirements.
Note
If you want to adjust the Zone 2 volume level by using the amplifier in the second room, we recommend setting the Zone 2 volume level
to or near 2.5 dB.

ZONE 2

REMOTE
IN
OUT
Yamaha component
This unit
This unit
Infrared emitter
Main room (Main Zone)
REMOTE
IN
OUT
Yamaha component
Amplifier
Zone 2
Remote control
(R-S700 only) Infrared signal
receiver
Second room (Zone 2)
ZONE 2
REMOTE
OUT
45
En