Table of Contents
Advertisement
You will obtain a better drying
performance if you select the
Combi Tablet function in cases
where you use a multi-purpose
detergent.
To add a function to the programme:
1.
Select the programme by pressing
programme selection button (4).
2.
Press the button of the function that
you want to enable and check to
see thee indicator for the relevant
function on the display.
3.
You can start the programme by
pressing the Start / Pause / Cancel
button (2).
Programme Steps Follow-up
You can follow up the step while
current programme is running from the
Programme Steps follow up indicator
(20)
a Washing Step Indicator (20 a)
b Rinsing Step Indicator (20 b)
c Drying Step Indicator (20 c)
d End of Programme Indicator (20 d)
The display shows the steps for
washing 20 a, rinsing 20 b and drying
20 c, respectively, while the selected
programme is running. Only the End
of Programme indicator 20 d lights up
when the programme is over. Remaining
Time Indicator (3) displays "00:00".
Canceling a Programme
Press Start / Pause / Cancel button
(2) for three seconds to cancel a
programme that is already running.
Release the button when
(12) start flashing in the display. For a
couple of minutes the machine will fulfill
the necessary operations required for
cancellation. Remaining time indicator
(11) displays "00:00". You may select
and operate a new programme following
the programme cancellation process.
There might be residues of detergent or
rinse aid left in the machine and/or on
the pieces being washed depending on
the step the previous programme was in
at the time of such cancellation.
Changing a Programme
If you want to change running
programme, first of all press Start /
Pause / Cancel button (2) to switch your
machine into pause mode. Second,
switch to the desired programme by
pressing Programme Selection button
(4). Third, Start the new programme
by pressing Start / Pause / Cancel
button (2) again. Your new selection will
resume operation from the step in the
previous programme (For example, if
the previous programme was in rinsing
step, the new one will also start from
the rinsing step). If you want to run
the newly selected programme from
the beginning, you have to apply the
programme cancellation process first
and then select a new programme.
Programming the Delayed Start
You can delay the start of the selected
programme until 24 hours. Delayed start
can not be set after the programme
starts. The selected programme must
not be started in order to be able to set
the delay time.
Delayed start indicator
will start flashing when the Time Delay
Button (8) is pressed. You can set the
symbol
desired time by pressing the Time Delay
Button (8). Press the Start / Pause /
Cancel button (2) after setting the time.
The delayed start indicator
(13) and play icon (12) will remain lit
23 GB
sand glass (13)
sand glass
Advertisement
Table of Contents
