Table of Contents
Advertisement
selecting the desired programme until
Half Load Indicator lights up, then
press Start / Pause / Cancel button and
close the door of your machine.
To use the Half Load and Tablet
Detergent functions concurrently,
turn on your machine by pressing the
On / Off button and then press the
Half Load / Tablet Detergent button
until Half Load and Tablet Detergent
Indicators illuminate together.
If you have used the Half Load or
Tablet Detergent features during the
last programme you used, Half Load or
the Tablet Detergent function will
remain active in the next washing
programme you will select. If you do
not want to use these functions in the
new programme you have selected,
press the Half Load / Tablet Detergent
button until the indicator of the relevant
function turns off.
Delayed Start Button (6)
You can delay the start of the selected
program until 9 hours with increments
of 1 hour by means of the Delayed
Start Function.
Program Selection
You can select the desired program
after turning on the machine by
pressing the On / Off button (1).
Switch to the program you want to
operate by pressing program selection
button (4). You can follow up the
program you are in from the program
indicator (8) on the screen. Program
number will increase by one each time
you press the program selection button
(Number of the defined programs can
change depending on the model you
have purchased). The selected
washing program will start running
when the Start / Pause / Cancel button
(2) is pressed
Time indicator (11) will start displaying
the estimated remaining time to the
end of program.
Total time can be different from
the time indicated at the beginning
since it can change while the
program is running, depending
on the temperature of the room
where your machine is installed,
temperature of the supply water,
auto-cleaning of the water softening
system (regeneration) and amount
of the dishes.
Adding Functions to the
Program
With the help of the add function
buttons, you can run the selected
program together with the Half Load
(5) and Delayed Start (6) functions.
To add a function to the program:
1.
Select the program by pressing
program selection button (4).
2.
Press the button of the function
that you want to enable and check
to see a indicator for the relevant
function on the display.
3.
You can start the program by
pressing the Start / Pause / Cancel
button (2).
Program Steps Follow-up
You can follow up the step while
current program is running from the
Program Steps follow up indicator (15)
a Washing Step Indicator (15 a)
20 GB
symbol (12) light up.
Advertisement
Table of Contents
