Table of Contents
Advertisement
USB 2.0 Headers
(9-pin USB6_7)
(see p.10 No. 17)
(9-pin USB4_5)
(see p.10 No. 18)
Infrared Module Header
(5-pin IR1)
(see p.10 No. 29)
Internal Audio Connector
(4-pin CD1)
(CD1: see p.10 No. 23)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.10 No. 21)
1. High Definition Audio supports Jack Sensing, but the panel wire on the
chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. Enter BIOS Setup Utility. Enter Advanced Settings, and then select
Chipset Configuration. Set the Front Panel Control option from
[Auto] to [Enabled].
2 0
2 0
2 0
2 0
2 0
Besides four default USB 2.0
USB_PWR
P-7
ports on the I/O panel, there are
P+7
GND
DUMMY
two USB 2.0 headers on this
1
motherboard. Each USB 2.0
GND
header can support two USB
P+6
P-6
USB_PWR
2.0 ports.
USB_PWR
P-4
P+4
GND
DUMMY
GND
P+5
P-5
USB_PWR
IRTX
This header supports an
+5VSB
DUMMY
optional wireless transmitting
1
and receiving infrared module.
GND
IRRX
This connector allows you
to receive stereo audio input
from sound sources such as
CD1
a CD-ROM, DVD-ROM, TV
tuner card, or MPEG card.
This is an interface for front
GND
PRESENCE#
MIC_RET
panel audio cable that allows
OUT_RET
convenient connection and
1
control of audio devices.
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
Advertisement
Table of Contents
