Beko DNE 61100 DPX Manual page 15

Water Spring
In addition to allowing you to obtain cold water
without opening the door of your refrigerator,
this accessory also helps you to save energy
since you do not need to open and close the
door of your refrigerator frequently and thus,
the cold air is kept inside.
Using the water spring
Press in the latch of the water spring with your
glass. Water spring will open and water will
pour into your glass. Latch of the water spring
will return to its original position and water flow
Filling in the water reservoir
Open the lid of the water reservoir located
inside of the door as illustrated and fill in with
water at room temperature or colder using a
carafe. Close the lid.
You can remove the water reservoir to fill it
outside the refrigerator and also to clean it.
You can easily carry the water reservoir by its
handle.
Warning!
Water spring is only intended for use with
drinking water. Do not put hot water, juice,
milk and gaseous or alcoholic beverages into
the water reservoir.
If there is a power failure (water can not be
obtained from the water dispenser if your
refrigerator is not energized.)
Dripping Crenel
Water drops that drip while using your water
spring accumulates in the dripping crenel at
the lower side. Remove the dripping crenel
to remove the accumulated water. You can
remove the water with a sponge or a soft
cloth.
Cleaning the water reservoir
Take out the water reservoir after removing
the cover mechanism on the left hand side
as illustrated in the figure. Clean the water
reservoir with warm water, replace it and close
the cover on the left hand side.
Make sure that the cover on the right hand
side fits into the water inlet hole after installing
the water reservoir. Otherwise, water leakage
may occur.
(Washing in the dishwasher may cause the
water reservoir to get scratched.)
14 EN