Pioneer CT-W404R Operating Instructions Manual page 15

I TAPE COPYING (from DECK I to DECK II) I
4'42
: . :t
_--,-_ _=====_m- ,-._--_ _
T !
f .=
I
1 1
• The tape copying function permits you to copy the contents of a
tape from DECK I to Deck I1.
• The SYNCHRO COPY button is used to select either normal speed
copying, or high-speed copying (copying at twice the normal play-
back speed).
1. Load a tape for playback into DECK I and a tape for re-
cording into Deck II.
2. Set the REV MODE switch. (CT-WS04R/CT-W404R)
3. Set the tape transport direction. (CT-W504R/CT-
W404R)
• Tape copying is always performed in the direction indicated by
the tape transport indicator (_.-or 41). To change this direction,
press the desired playback button (t., or ,4), then immediately
press the stop (11)button.
4. Press the SYNCHRO COPY button to select either
NORMAL or HIGH speed.
NORMAL : Tape copying at normal speed allows listen during
playback (COPY indicator lights steadily).
HIGH : Tape copying at twice the normal speed (COPY
indicator flashes). Playback will still audible.
( 4' is CT-W404R/CT-W204 only at NORMAL )
To stop copying
Press the stop (i) button of either deck. Both decks will stop.
NOTES:
• The tape in DECK II will be copied in the same type of the
DOLBY NR switch as DECK rs tape, regardless of its own
setting. When listening to the copied tape, set the type of
the DOLBY NR switch.
• If a nearby television set is on while high-speed copying is being
performed, a high-pitched interference sound may be heard on
the tape, In this case, either use the normal speed copying
function, or turn off the television.
• During high-speed copying, none of the operation buttons will
function except for the stop (in) button.
• During normal speed copying, the recording mute (0) and
pause (.)buttons of deck II also function.
• Tape copying is cancelled when either of the two tapes reaches
the end. Therefore it is advisable to use tapes of the same
length.
• The sound quality of the copied tape will be somewhat less than
the original. Therefore when making more than one copy, al-
ways record from the original tape (do not make a copy of a
copy).
• The recording level adjustment is not necessary during tape
copying.
15
<RRB1155>
En