Pioneer CT-W404R Operating Instructions Manual page 14

RECORDING
]
CD • DECK SYNCHRO RECORDING
(CT-W504R only)
4 396
U
!
8 7 2
I
If the CD player has a program function to determine the order of
playback, program the CD player before beginning this operation.
1. Load a compact disc in the CD player.
2. Load the cassette for recording.
• Rewind the tape to the desired starting position.
3. Set the REV MODE switch.
• To record on one side only, set the switch to the --" position.
To record on both sides, set the switch to either the _;_or the
O position.
4. Set the DOLBY NR switch.
5. Press the play button of the CD player.
6. Press the recording (e) button.
7. Adjust the recording level.
• Seepage 13.
8. Press the stop (11) button of both the cassette deck
and the CD player.
• Unless both this deck and the CD player are in stop mode,
synchro recording cannot be performed.
9. Press the CD SYNC button.
• The cassette deck begins recording, and the CD player begins
playback.
• Although recording begins when the CD SYNC button is
pressed, the CD player does not start playback until the button
is released. This function can be used to advance the tape
past the leader section, or to create a blank section on the
tape.
When the end of the tape is reached while the CD
player is still playing:
The CD player returns to the beginning of the selection currently
playing and then enters the pause mode. To resume recording, load
another tape and check the tape running indicator to ensure that the
tape is moving in the desired direction. If not, press the playback (re,-
or _1) button to change the tape direction, then immediately press
the stop (i) button. The tape running indicator will change direction.
Synchro recording can be resumed by pressing the CD SYNC button
again. (The CD SYNC button should be pressed within 1 minute. If
more than I minute elapses, the CD player will enter stop mode.)
ff the auto-reverse function operates while the CD
is still playing:
The CD player returns to the beginning of the current selection and
enters pause mode.
A ten-second blank space is automatically created on the reverse
side, then the CD player resumes playback and the deck resumes
recording.
NOTES:
• The CD • DECK SYNCHRO function only works with PIONEER
CD players equipped with the CD • DECK SYNCHRO function.
• Be sure to connect the deck and the CD player with the CD •
DECK SYNCHRO control cord.
• Only PIONEER CD players equipped with a CD. DECKSYN-
CHRO jack can be used for CD • DECK SYNCHRO recording. Any
type of CD player which meets these requirements, including
twin-tray or multiplay models, can be used.
When the compact disc finishes playing:
The CD player enters stop mode and the cassette deck enters
recording standby mode. Change the disc and press the play button
of the CD player to resume recording.If the CD player does not
resume play within one minute, the cassette deck enters stop mode.
When the CD player changes discs
(twin tray or multi-play disc CD players):
The cassette deck enters recording standby mode, and resumes
recording when the CD player begins playing the next disc. A four-
second blank space is automatically created between tracks.
14
<RRB1155>
En