Pads - GE asd06lk Owner's Manual & Installation Instructions

About the controlson the air conditionermmodels with touchpads.
Features and appearance will vary.
COOL Oft
ENE£GY
SAVE£ On
SLEEP On
@
@
@
Air ConditionerControls
Remote Control
4
) On/Off
G
Turns air conditioner
on and off.
O Display
@
O
0
Displays tile set temperature
or time
remaining on fime_:
Mode
Use to set tile air conditioner to Cool or Fan
I/lode.
Increase •/Decrease • Pads
Use to set temperature when
in Cool mode.
Fan
Use to set tile tim speed at Low, Medor High.
o girculaire (on some models)
TtlYn on to
provide
('ontintlOtlS side-to-side
air circulation.
For fixed side-to-side air direction, mrn On
until the desired air direction is obtained,
then mrn it Off.
O Energy Saver-Controls
tile tim.
On--The
tilll and compressor cycle on and
off. This results in wider \miations of room
temperature and humidit,i. Nommlly used
when the room is tmoccui)ied. Note: The fan
will continue to run for a short time after the
compressor cycles oK
O/'/JThe tiln rtlns all tile time, while tile
compressor cycles on and otE
This switch must be set at O//in order to use
the tim settings (on the mode control).
0
Timer
On--X,Vhen tile air conditioner is off, it can be
set to automatically mrn on in 1 to 24 hom_
at its i)revious setting. Each touch will set tile
time in hom_.
O/'/J]'_ hen
tile air conditioner is on, it can
be set to automatically turn off in 1 to 24
hou_. Each touch will set tile time in hom_.
To cancel tile timex; press tile Timerpad
tmtil tile display time disappears.
Sleep (on some models)
Press to set tile air conditioner to run fi)r
8 ho/u_ befi)re it automatically shuts off'.
One hour after tile sleep timer is set, tile set
temperature will automatically increase 2°F.
To cancel the sleep mode, press the Sleep pad
a second time.
Note: Thesleep timer will be cancelled if the
Timer,Energy Saver or Mode pad is pressed.
Remote Control Signal Receiver
Remote Control
To ensure proper operation, aim tile
remote control at tile signal receixer
on tile air conditione_:
Tile remote control signal has a range of
( c
up t ) 21 teet.
Make sure nothing is between tile air conditioner
and the remote control that could block the
signal.
Make sure batteries are fl'esh and installed
correctly see the Care and Cleaning section.