GE asd06lk Owner's Manual & Installation Instructions page 11

Window mnstamiation mnsttuctions
[] WINDOW REQUIREMENTS
• These instructions are for a standard
double-hung window. You will need to
modify them for other types of windows.
• All supporting parts must be secured
to firm wood, masonry or metal.
• The electrical outlet must be within
reach of the power cord.
Models ASD06, ASM08, ASQ10, ASVl0 only
(See below illustration for Models ASM10, ASM12,
ASQ12, ASV12, ASQ14, ASV14.)
143A"min.
243/4" to 36"
(With accordion panels)
fl-
Models ASM10, ASM12, ASQ12,
ASV12, ASQ14, ASV14 only
(Seeabove illustration for Models ASD06,
ASM08,ASQ10,ASVl0.)
1
l 16¼" min.
26" to 39W'
(With accordion panels)
[]
[]
[]
STORM WINDOW REQUIREMENTS
A storm window frame will not allow the
air conditioner to tilt toward the outside,
and will keep it from draining properly.
To adjust for this, attach a piece of wood
to the stool.
WOOD PIECES-
WIDTH: 2"
LENGTH: Long enough to fit inside the
window frame.
THICKNESS: To determine the thickness,
place a piece of wood on the stool to
make it 1/2" higher than the top of the
storm window frame or the vinyl frame.
Attach securely with nails or screws
provided by the installer.
1/2" higher
than vinyl frame
L (on some windows)
/
ll!
___ --Wood
1/2" higher _
than storm _- r f"_l Jr b"/._
window _-1"1_ II 1[L1" / _1_ ............
frame __tool _'
Storm window •
frame /- S Vinyl frame I I
[]
[]
REMOVE THE FRONT GRILLE
(IF ATTACHED)
Remove shipping tape, if present.
On models with a
raise-up inlet grille,
lift it and remove
the screw behind it
(if present) that holds
the grille in place.
On models with a
slide-out air filter,
remove it and the
screw behind it
(if present) that holds
the grille in place.
Gently but firmly grasp
the lower grille corners,
press in on the case
sides and pull forward
to release.
NOTE: Do not pull the
bottom edge toward
you more than 3" or
you may damage the tabs of the grille,
Lift the grille up and off the top tabs.
!itt
11