ASROCK P45TS - V1.0 User Manual page 25

Serial ATA (SATA)
Power Cable
(Optional)
connect to the SATA HDD
power connector
USB 2.0 Headers
(9-pin USB6_7)
(see p.11/12 No. 19)
(9-pin USB4_5)
(see p.11/12 No. 18)
WiFi/E Header
(15-pin WIFI/E)
(see p.11 No. 32 or p.12 No. 31)
If you don't plan to use WiFi+AP functin on this motherboard, this header can be
used as a 4-Pin USB 2.0 header to support one USB 2.0 port. To connect the
4-Pin USB device cable to this header, please refer to
this picture for proper installation.
Infrared Module Header
(5-pin IR1)
(see p.11 No. 26 or p.12 No. 25)
Please connect the black end of
SATA power cable to the power
connector on each drive. Then
connect the white end of SATA
connect to the power cable to the power
power supply
connector of the power supply.
Besides six default USB 2.0
USB_PWR
P-7
ports on the I/O panel, there are
P+7
GND
DUMMY
two USB 2.0 headers on this
motherboard. Each USB 2.0
1
GND
header can support two USB
P+6
P-6
2.0 ports.
USB_PWR
USB_PWR
P-5
P+5
GND
DUMMY
1
GND
P+4
P-4
USB_PWR
This header supports WiFi+AP
USB+5V_2
function with ASRock
TXN
TXP
GND2
WiFi-802.11g or WiFi-802.11n
PCIE_RST#
+3SVB
RXN RXP
module, an easy-to-use wireless
1
local area network (WLAN)
PexCLK
GND1
D0- D0+ PexCLK#
adapter. It allows you to create a
PME#
USB+5V_1
wireless environment and enjoy the
convenience of wireless network
connectivity.
This header supports an
IRTX
+5V
DUMMY
optional wireless transmitting
and receiving infrared module.
1
GND
IRRX
2 5 2 5 2 5
2 5 2 5