ASROCK N68PV-GS - V1.0 User Manual page 41

Multiplier/Voltage Change
This item is set to [Auto] by default. If it is set to [Manual], you may adjust the
value of Processor Frequency and Processor Voltage. However, it is recom-
mended to keep the default value for system stability.
BIOS SETUP UTILITY
Advanced
CPU Configuration
AM2 Boost
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
CPU/LDT Spread Spectrum
PCIE Spread Spectrum
SATA Spread Spectrum
Boot Failure Guard
Cool' n' Quiet
Secure Virtual Machine
Enhanced Halt State
Processor Maximum Frequency
Processor Maximum Voltage
Multiplier/Voltage Change
Processor Frequency
Processor Voltage
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Processor Frequency
This option appears only when you adopt AM2 CPU. This item will show when
"Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be hidden. The
range of the value depends on the CPU you adopt on this motherboard. However,
for system stability, it is not recommended to adjust the value of this item.
Processor Voltage
This option appears only when you adopt AM2 CPU. This item will show when
"Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be hidden. The
range of the value depends on the CPU you adopt on this motherboard. However,
for safety and system stability, it is not recommended to adjust the value of
this item.
Processor Target Frequency
This option appears only when you adopt Phenom CPU. This item will show
when "Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be hidden.
The range of the value depends on the CPU you adopt on this motherboard.
However, for system stability, it is not recommended to adjust the value of this
item.
North Bridge Target Frequency
This option appears only when you adopt Phenom CPU. This item will show
when "Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be hidden.
The range of the value depends on the CPU you adopt on this motherboard.
However, for safety and system stability, it is not recommended to adjust the
value of this item.
If AUTO, multiplier and
[Disabled] voltage will be left at the
[Auto] rated frequency/voltage. If
Manual, multiplier and
[200]
voltage will be set based
[100]
on User Selection in Setup.
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Auto]
Select Screen Select Screen
[Enabled]
[Disabled] Select Item Select Item
+- +- Change Option Change Option
x11.5 2300 MHz
F1 F1 General Help General Help
1.300 V
F9 F9 Load Defaults Load Defaults
[Manual]
F10 F10 Save and Exit Save and Exit
[x9.0 1800 MHz]
ESC ESC Exit Exit
[1.350 V]
4 1 4 1 4 1 4 1 4 1