ASROCK M3A760GMH - V1.0 User Manual page 39

Spread Spectrum
This item should always be [Auto] for better system stability.
Boot Failure Guard
Enable or disable the feature of Boot Failure Guard.
Boot Failure Guard Count
Enable or disable the feature of Boot Failure Guard Count.
Advanced Clock Calibration
This allows you to adjust Advanced Clock Calibration feature. The default
value is [Disabled]. Configuration options: [Disabled], [Auto], [All Cores] and
[Per Core]. If you select [All Cores], you will see the option "Value (All
Cores)". Configuration options: [+12%] to [-12%]. If you select [Per Core],
you will see the options "Value (Core 0)", "Value (Core 1)", "Value (Core 2)
" and "Value (Core 3)". Configuration options: [+12%] to [-12%].
CPU Active Core Control
This allows you to adjust CPU Active Core Control feature. The configura-
tion options depend on the CPU core you adopt. The default value is [All
Cores].
Processor Maximum Frequency
It will display Processor Maximum Frequency for reference.
North Bridge Maximum Frequency
It will display North Bridge Maximum Frequency for reference.
Processor Maximum Voltage
It will display Processor Maximum Voltage for reference.
Multiplier/Voltage Change
This item is set to [Auto] by default. If it is set to [Manual], you may adjust the
value of Processor Frequency and Processor Voltage. However, it is
recommended to keep the default value for system stability.
BIOS SETUP UTILITY
Main OC Tweaker Advanced
Load Optimized CPU OC Setting
Load Optimized mGPU OC Setting
CPU Configuration
Overclock Mode
CPU Frequency (MHZ)
CPU DOC Frequency (MHZ)
PCIE Frequency (MHz)
Spread Spectrum
Boot Failure Guard
Boot Failure Guard Count
Advanced Clock Calibration
CPU Active Core Control
Processor Maximum Frequency
North Bridge Maximum Frequency
Processor Maximum Voltage
Multiplier/Voltage Change
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
H/W Monitor Boot Security Exit
[Press Enter]
If Manual, multiplier
[Press Enter]
and voltage will be
set based on user
selection. Final
result is depending
[Auto] on CPU's capability.
[200]
And Cool 'n' Quiet
[Auto]
will be disabled.
[100]
[Auto]
[Enabled]
Select Screen
[3]
Select Item
[Disabled]
Enter Go to Sub Screen
[All Cores]
F1 General Help
x10.5 2100 MHZ
F9 Load Defaults
x9.0 1800 MHZ
F10 Save and Exit
1.2500 V
ESC Exit
[Manual]
3 9 3 9 3 9 3 9 3 9