Table of Contents
Advertisement
Primary Graphics Adapter
This item will switch the PCI Bus scanning order while searching for video
card. It allows you to select the type of Primary VGA in case of multiple
video controllers.
HT Width
For 754-Pin CPU, you may set the HyperTransport width as [8 bit], [16 bit] or
[Auto]. For 939-Pin CPU (if ASRock 939CPU Board is installed into the
FUTURE_CPU_PORT on this motherboard), you may set the HyperTransport
width as [8 bit] or [Auto]. The default value is [Auto].
HT Speed
For both 754-Pin CPU and 939-Pin CPU (if ASRock 939CPU Board is
installed into the FUTURE_CPU_PORT on this motherboard), you may set
the HyperTransport speed as [Auto], [200 MHz], [400 MHz], [600 MHz], or
[800 MHz]. The default value is [Auto].
3.3.3 ACPI Configuration
Advanced
ACPI Settings
Suspend To RAM
Repost Video on STR Resume
Restore on AC / Power Loss
Ring-In Power On
PCI Devices Power On
PS / 2 Keyboard Power On
RTC Alarm Power On
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Suspend to RAM
Use this item to select whether to auto-detect or disable the Suspend-to-
RAM feature. Select [Auto] will enable this feature if the OS supports it. If
you set this item to [Disabled], the function "Restore on AC/Power Loss"
will be hidden.
Restore on AC/Power Loss
If you set the item "Suspend to RAM" to [Auto], you may use this item to set
the power state after an unexpected AC/Power loss. If [Power Off] is
selected, the AC/power remains off when the power recovers. If [Power
On] is selected, the AC/power resumes and the system starts to boot up
when the power recovers.
BIOS SETUP UTILITY
[Auto]
[No]
[Power Off]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
Select auto-detect or
disable the STR
feature.
Select Screen
Select Item
+-
Change Option
F1
General Help
F9
Load Defaults
F10
Save and Exit
ESC
Exit
Advertisement
Table of Contents
