ASROCK K7VM4 User Manual page 6

1. PC1600 (DDR200) is supported ONLY when using
FSB200 (Duron) processor.
2. While CPU overheat is detected, the system will automati-
cally shutdown. Please check if the CPU fan on the
motherboard functions properly before you resume the
system. To improve heat dissipation, remember to spray
thermal grease between the CPU and the heatsink when
you install the PC system.
3. Do NOT insert a 3.3V AGP card into the AGP slot of
K7VM4 motherboard! It may cause permanent damage!
4. Power Management for USB 2.0 works fine under
®
Microsoft Windows
®
Microsoft Windows
®
Microsoft official document at
http://www.microsoft.com/whdc/hwdev/bus/USB/USB2support.mspx
5. Although K7VM4 offers stepless control, it is not
recommended to perform over clocking. When the CPU
frequency of K7VM4 is set to perform over clocking,
other clocks, such as PCI clock, AGP clock, and Memory
clock will also be overclocked proportionally.
Frequencies other than the recommended CPU bus
frequencies may cause the instability of the system or
damage the CPU.
®
XP. It may not work properly under
®
98/ME/2000. Please refer to