Table of Contents
Advertisement
3.3.2 Chipset Configuration
Advanced
Chipset Configuration
DRAM Frequency
Flexibility Option
DRAM CAS# Latency
DRAM Command Rate
DRAM Bus Selection
Primary Graphics Adapter
AGP Aperture Size
AGP Mode
AGP Fast Write
IDE Drive Strength
PCI Delay Transaction
OnBoard LAN
OnBoard AC'97 Audio
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
DRAM Frequency
If [Auto] is selected, the motherboard will detect the memory module(s)
inserted and assigns appropriate frequency automatically. You may also
select other value as operating frequency: [133MHz (DDR 266)],
[166MHz (DDR 333)], [200MHz (DDR 400)].
Flexibility Option
The default value of this option is [Disabled]. It will allow better tolerance for
memory compatibility when it is set to [Enabled].
DRAM CAS# Latency
Use this item to adjust the means of memory accessing. Configuration
options: [Auto], [2.5], [2], and [3].
DRAM Command Rate
Use this to select among [2T Command] and [1T Command] for DRAM
Command Rate. The default value is [2T Command].
DRAM Bus Selection
The default value is [Auto], which will automatically select the proper ac-
cess mode for the system. You may select between [Single Channel] and
[Dual Channel] if you have properly set the dual channel memory
configuration.
Primary Graphics Adapter
This allows you to select [PCI] or [AGP] as the primary graphics adapter.
The default vaule is [PCI].
AGP Aperture Size
It refers to a section of the PCI memory address range used for graphics
memory. It is recommended to leave this field at the default value unless the
installed AGP card's specifications requires other sizes.
BIOS SETUP UTILITY
[Auto]
[Disabled]
[Auto]
[2T Command]
[Auto]
[PCI]
[64MB]
[Auto]
[Disabled]
[Normal]
[Disabled]
[Enabled]
[Auto]
Options
133MHz (DDR266)
166MHz (DDR333)
200MHz (DDR400)
Auto
Select Screen
Select Item
+ -
Change Option
F1
General Help
F9
Load Defaults
F10
Save and Exit
ESC
Exit
Advertisement
Table of Contents
