ASROCK FATAL1TY P67 PROFESSIONAL Series User Manual page 37

Primary IDE connector (Black)
(39-pin IDE1, see p.16 No. 9)
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATA2_2: see p.16, No. 14)
(SATA2_3: see p.16, No. 13)
(SATA2_4: see p.16, No. 12)
(SATA2_5: see p.16, No. 11)
Serial ATA3 Connectors
(SATA3_0: see p.16, No. 16)
(SATA3_1: see p.16, No. 15)
(SATA3_M1: see p.16, No. 18)
(SATA3_M2: see p.16, No. 17)
(SATA3_M3: see p.16, No. 20)
(SATA3_M4: see p.16, No. 19)
We recommend to use Intel
SATA2_2, SATA2_3, SATA2_4 and SATA2_5) for your bootable
devices. This will minimum your boot time and get the best
performance. But if you still want to boot from Marvell SATA3
controller, you can still enable Marvell SATA3 Bootable in UEFI. If
you want to install USB 3.0 device on Marvell SATA3 port, please use
SATA3_M1 and SATA3_M2 as the fi rst priority for better performance.
Serial ATA (SATA)
Data Cable
(Optional)
connect the black end
to the IDE devices
These four Serial ATAII (SATAII)
connectors support SATA data
cables for internal storage
devices. The current SATAII
interface allows up to 3.0 Gb/s
data transfer rate.
These six Serial ATA3 (SATA3)
connectors support SATA data
cables for internal storage
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate. If you install
the HDD on the eSATA port on
the rear I/O, the internal
SATA3_M4 will not function.
®
P67 SATA ports (SATA3_0, SATA3_1,
Either end of the SATA data
cable can be connected to the
SATA / SATAII / SATA3 hard
disk or the SATAII / SATA3
connector on this motherboard.
37