Network Connection - ASROCK MultiBook F24 User Manual

Network Connection

Connect a network cable, with RJ-45 connectors on each end, to the modem/network port on the
Notebook PC and the other end to a hub or switch. For 100 BASE-TX / 1000 BASE-T speeds,
your network cable must be category 5 or better (not category 3) with twisted-pair wiring. If
you plan on running the interface at 100/1000Mbps, it must be connected to a 100 BASE-TX
/ 1000 BASE-T hub (not a BASE-T4 hub). For 10Base-T, use category 3, 4, or 5 twisted-pair
wiring. 10/100 Mbps Full-Duplex is supported on this Notebook PC but requires connection to
a network switching hub with "duplex" enabled. The software default is to use the fastest setting
so no user-intervention is required.
1000BASE-T (or Gigabit) is only supported on selected models.
Example of the Notebook PC connected to a Network Hub or Switch for use with the
built-in Ethernet controller.
Network Hub or Switch
Using the Notebook PC
LAN
connector
Network cable with RJ-45 connectors
4
35