Connections; Modem Connection - ASROCK MultiBook F24 User Manual

4
Using the Notebook PC

Connections

NOTE: The built-in modem and network cannot be installed later as an upgrade. After
purchase, modem and/or network can be installed as an expansion card.

Modem Connection

The telephone wire used to connect the Notebook PC's internal modem should
have either two or four wires (only two wires (telephone line #1) is used by the
modem) and should have an RJ-11 connector on both ends. Connect one end
to the modem port and the other end to an analog telephone wall socket (the
ones found in residential buildings). Once the driver is setup, the modem is
ready to use.
NOTE: When you are connected to an online service, do not place the Notebook PC
in suspend (or sleep mode) or else you will disconnect the modem connection.
Example of the Notebook PC connected to a telephone jack for use with the built-in
modem:
WARNING! Only use analog telephone outlets. The built-in modem does not support
the voltage used in digital phone systems. Do not connect the RJ-11 to digital phone
systems found in many commercial buildings or else damage will occur!
CAUTION: For electrical safety concerns, only use telephone cables rated 26AWG or
higher.
34
Telephone cables
with RJ-11 connectors
Telephone Wall
Jack
Telephone connector
Telephone
connection is
optional