ASROCK A780GXH 128M - V1.1 User Manual page 49

BIOS SETUP UTILITY
Advanced
CPU Configuration
AM2 Boost
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
Spread Spectrum
Boot Failure Guard
Cool' n' Quiet
Secure Virtual Machine
L3 Cache Allocation
Processor Maximum Frequency
Processor Maximum Voltage
Multiplier/Voltage Change
Processor Frequency
Processor Voltage
Memory Clock
Flexibility Option
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Processor Frequency
This option appears only when you adopt AM2 CPU. This item will show when
"Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be hidden. The
range of the value depends on the CPU you adopt on this motherboard. However,
for system stability, it is not recommended to adjust the value of this item.
Processor Voltage
This option appears only when you adopt AM2 CPU. This item will show when
"Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be hidden. The
range of the value depends on the CPU you adopt on this motherboard. However,
for safety and system stability, it is not recommended to adjust the value of
this item.
CPU Frequency Multiplier
This option appears only when you adopt Phenom CPU. However, for safety
and system stability, it is not recommended to adjust the value of this item.
CPU Voltage
This option appears only when you adopt Phenom CPU. It allows you to adjust
the value of CPU voltage. However, for safety and system stability, it is not
recommended to adjust the value of this item.
NB Frequency Multiplier
This option appears only when you adopt Phenom CPU. However, for safety
and system stability, it is not recommended to adjust the value of this item.
NB Voltage
This option appears only when you adopt Phenom CPU. It allows you to adjust
the value of NB voltage. However, for safety and system stability, it is not
recommended to adjust the value of this item.
Memory Clock
This item can be set by the code using [Auto]. You can set one of the standard
values as listed: [200 MHz (DDR2 400)], [266 MHz (DDR2 533)],
[333 MHz (DDR2 667)] and [400MHz (DDR2 800)]. If you adopt Phenom CPU,
there is one more option: [533MHz (DDR2 1066)].
If AUTO, multiplier and
voltage will be left at the
[Disabled]
[Auto] rated frequency/voltage. If
Manual, multiplier and
[200]
voltage will be set based
[100]
on User Selection in Setup.
[Auto]
[Enabled]
[Auto]
[Enabled]
[BSP Only]
Select Screen Select Screen
x15.0 3000 MHz
Select Item Select Item
1.400 V
+- +- Change Option Change Option
[Manual]
F1 F1 General Help General Help
[x9.0 1800 MHz]
F9 F9 Load Defaults Load Defaults
[1.350 V]
F10 F10 Save and Exit Save and Exit
[Auto] ESC ESC Exit Exit
[Disabled]
4 9 4 9 4 9 4 9 4 9