Onboard Headers And Connectors - ASROCK 890GX EXTREME3 User Manual

2.9 Onboard Headers and Connectors

2.9 Onboard Headers and Connectors
2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA3 Connectors
(SATA3_1_2: see p.11, No. 17)
(SATA3_3_4: see p.11, No. 16)
(SATA3_5_6: see p.11, No. 15)
Serial ATA (SATA)
Data Cable
(Optional)
Serial ATA (SATA)
Power Cable
(Optional)
connect to the SATA HDD
power connector
eSATA3 Bracket
(Optional)
These six Serial ATA3
(SATA3) connectors support
SATA data cables for internal
storage devices. The current
SATA3 interface allows up to
6.0 Gb/s data transfer rate. If
you install the HDD on the
eSATA port on the rear I/O,
the internal SATA3_6 will not
function.
Either end of the SATA data cable
can be connected to the SATA3
hard disk or the SATA3
connector on this motherboard.
Please connect the black end of
SATA power cable to the power
connector on each drive. Then
connect the white end of SATA
power cable to the power
connect to the
connector of the power supply.
power supply
eSATA3 bracket can be
connected to the onboard SATA
connector to support the
external SATA3 device.
3 1 3 1 3 1 3 1 3 1