Oc Tweaker Screen - ASROCK 880GXH-USB3 - V1.0 User Manual

3.3 OC T 3.3 3.3 OC Tweak OC T OC T weaker Screen weak weak er Screen er Screen er Screen
3.3 3.3 OC T weak er Screen
In the OC Tweaker screen, you can set up overclocking features.
Main OC Tweaker Advanced
EZ Overclocking
Turbo 50
Load Optimized CPU OC Setting
Load Optimized mGPU OC Setting
CPU Configuration
Overclock Mode
CPU Frequency (MHZ)
PCIE Frequency (MHz)
Spread Spectrum
Boot Failure Guard
Boot Failure Guard Count
Advanced Clock Calibration
CPU Active Core Control
Processor Maximum Frequency
North Bridge Maximum Frequency
Processor Maximum Voltage
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
EZ Overclocking
Turbo 50
You can use this option to increase your system performance. Configura-
tion options: [Press Enter], [OFF], [System Performance Increases 40%]
and [System Performance Increases 50%].
Load Optimized CPU OC Setting
You can use this option to load the optiomized CPU overclocking setting.
Configuration options: [Press Enter], [Default], [5% (2940MHz)] to [50%
(4200MHz)]. Please note that overclocking may cause damage to your
CPU and motherboard. It should be done at your own risk and expense.
Load Optimized mGPU OC Setting
You can use this option to load the optiomized mGPU overclocking setting.
Configuration options: [Press Enter], [Default], [750MHz] to [1000MHz].
Please note that overclocking may cause damage to your mGPU and
motherboard. It should be done at your own risk and expense.
CPU Configuration
Overclock Mode
Use this to select Overclock Mode. The default value is [Auto]. Configura-
tion options: [Auto], [CPU, PCIE, Sync.], [CPU, PCIE, Async.] and [Optimized].
CPU Frequency (MHz)
Use this option to adjust CPU frequency.
PCIE Frequency (MHz)
Use this option to adjust PCIE frequency.
BIOS SETUP UTILITY
H/W Monitor Boot Security
Overclocking may cause
[Press Enter]
damage to your CPU and
[Press Enter]
motherboard.
[Press Enter]
It should be done at
your own risk and
expense.
[Auto]
[200]
[100]
[Auto]
[Enabled]
Select Screen
[3]
Select Item
[Disabled]
Enter Go to Sub Screen
[All Cores]
F1 General Help
F9 Load Defaults
x10.5 2100 MHZ
F10 Save and Exit
x9.0 1800 MHZ
1.2500 V
ESC Exit
4 0 4 0 4 0 4 0 4 0
Exit